GE JGBS02EM Use And Care & Installation Manual page 44

HOW TO CONVERT THE RANGE FOR USE
WITH 1P GAS OR NATURAL GAS
CONVERT TOP BURNER VALVES
Only valves
NOTE:
with these types of
knobs are adjustable.
1. Turn all top burners to LOW.
2. Remove all four knobs.
3. With a small flat blade screwdriver, turn the
valve set screws clockwise to decrease flame
size, counterclockwise to increase flame size.
Adjust until the flame is about the same height
as the top of the burner.
Replace knobs.
4.
5. Check for flame outage by opening and
closing the oven door several times. If the flame
goes out, increase the flame size.
(continued)
(for models equipped with standing pilots)
small hole near the center
of the manifold panel.
3. To adjust, use a blade-type screwdriver with
a shaft diameter of less than 3/16". Turn pilot
not reduce the flame to less than 5/16" or pilot
than recommended may generate soot (carbon
black) on the bottom
to be determined visually.
Normal burner flames should look like (B) or
(C), depending on the type of gas you use.
With LP gas, some yellow tipping on outer cones
is normal.
ADJUST THE SURFACE BURNER PILOYS
screw until pilot is 5/16" high. D
of your cooktop.
(A) Yellow flames—
Call for service
(B) Yellow tips on
outer cones—
Normal for LP gas
(C) %R blue flamee
Normal for natural gas
O