GE JGBS02EM Use And Care & Installation Manual page 34

USage Sitiation.where Appliace
Power Cord ~ be Disconnected I&equen@.
An adapter maybe used only on a 15-amp
circuit. Do not use an adapter on a 20-amp
circuit. mere local codes permit, a
made to a properly grounded two-prong wall
receptacle by the use of a UL-listed adapter,
available at most hardware stores. The larger
slot in the adapter must be aligned with the
larger slot in the wall receptacle to provide
proper polarity in the connection of the
power cord,
TEMPORARY METHOD
(ADAPTER PLUGS NOT
PERMITTED
IN CANADA)
ALIGN LARGE
PRONGS/SLOTS
terminal to the wall receptacle cover screw
does not ground the appliance unless the cover
screw is metal, and not insulated, and the wall
receptacle is grounded through the house
wiring. The customer should have the circuit
checked by a qualified electrician to make sure
the receptacle is properly grounded.
adapter, always hold the adapter with one hand.
is very likely to break with repeated use. Should
this happen, DO N~ USE the appliance until a
proper ground has again been established.
34
(continued)
ENSURE PROPER
GROUND AND
FIRM CONNECTION
BEFORE USE
Situations
Cord ~ be Disconnected Frequen&.
Do not use an adapter plug in these situations
because disconnecting of the power cord
places undue strain on the adapter and leads to
eventual failure of the adapter ground terminal.
The customer should have the two-prong
wall receptacle replaced with a three-prong
before using the appliance.
The installation of appliances designed for
mobile home installation must conform with
the Manufactured Home Construction and
Safety Standard, Title 24 CFR, Part 3280
(formerly the Federal Stindard for Mobile
Home Construction and Safety, Title 24, HUD,
Part 280) or, when such standard is not
applicable, the Standard for Manufactured
Home Installations, latest edition (Manufactured
Home Sites, Communities and Set-Ups), ~SI
Canada, mobile home installation must be in
accordance with the current CN/CSA
Electric Disconnect
1. Locate disconnect plug on the range back.
2. Pinch sides of connector and pull out of
range back.
You will have one of these disconnect plugs.
--
where Appliance Power