Chauvet Batten 72 TOUR Quick Reference Manual page 3

EN
Power Linking
Fuse
Replacement
DMX Linking
DMX Connection
Master/Slave
Connection
Mounting
Product
Mounting
Diagram
You can link up to 6 COLORado™ Batten 72 Tour products at 120 VAC or
11 at 230 VAC. Power linking cords can be purchased separately.
1.
Disconnect the product.
2.
With a Phillips #2 head screwdriver, unscrew the fuse holder cap.
3.
Remove the blown fuse and replace it with a good fuse of the same
type and rating.
4.
Screw the fuse holder cap back in its place and reconnect power.
The COLORado™ Batten 72 Tour will work with a DMX controller using
a regular DMX serial connection. A DMX Primer is available from
www.chauvetpro.com.
The COLORado™ Batten 72 Tour uses a regular DMX data connection for
its DMX personalities: TOUR, BLOCK1, BLOCK2, ARC1, ARC1 + D,
ARC2, ARC2 + D, ARC2 + S, and HSV. See the User Manual to connect
and configure for DMX operation.
The COLORado™ Batten 72 Tour uses the DMX data connection for its
Master/Slave mode. See the User Manual to connect and configure for
Master/Slave operation.
COLORado™ Batten 72 Tour QRG
Overhead Mounting
Floor Mounting
3