Mounting - American DJ Vizi Roller Beam 2R User Instructions

Vizi Roller Beam 2R
When installing the unit, the trussing or area of installation must be
able to hold 10 times the weight without any deformation. When
installing the unit must be secured with a secondary safety attach-
ment, e.g. an appropriate safety cable. Never stand directly below the
unit when mounting, removing, or servicing the unit.
Overhead mounting requires extensive experience, including calculat-
ing working load limits, installation material being used, and perodic
safety inspection of all installation material and unit. If you lack these
qualifications, do not attempt the installation yourself.
These installaiton should be checked by a skilled person once a year.
The Vizi Roller Beam 2R is fully operational in three different mounting
positions, hanging upside-down from a ceiling, mounted sideways,
or set on a flat level surface. Be sure this fixture is kept at least 0.5m
away from any flammable materials (decoration etc.). Always use
and install the supplied safety cable as a safety measure to prevent
accidental damage and/or injury in the event the clamp fails (see next
page). Never use the carrying handles for secondary attachment.
ADJ Products, LLC - www.adj.com - Vizi Roller Beam 2R Instruction Manual Page 8

Mounting

Vizi Roller Beam 2R
NOTICE: The suitable enviromental temperature for this light-
ing fixture is between -25˚ C to 45˚ C. Do not place this lighting
fixture in an enviroment where the temperatures are under or
above the temperatures stated above. This will allow the fixture
to run at its best and help prolong the fixture life.
Screw one clamp each via a M12 screw and nut onto the
Omega holders. Insert the quick-lock fasteners of the first
Omega holder into the respective holes on the bottom of the
Vizi Roller Beam 2R. Tighten the quick-lock fasteners fully
clockwise. Install the second Omega holder. Pull the safety-
cable through the holes on the bottom of the base and over
the trussing system or a safe fixation spot. Insert the end in the
carabine and tighten the safety screw.
ADJ Products, LLC - www.adj.com - Vizi Roller Beam 2R Instruction Manual Page 9
Mounting