American DJ Vizi Roller Beam 2R User Instructions page 12

Vizi Roller Beam 2R
played, press ENTER.
3. Press UP or DOWN buttons, until "Lamp Time Password" is dis-
played, and press ENTER.
4. The "Lamp Time Password" is 038.
5. Press ENTER or press MODE/ESC to exit.
Clean Lamp Time - This will allow you to clear the lamp time run-
ning time. Please clear the lamp running time every time you replace
the lamp. You need to put in the Lamp Time Password before doing
this. Please see the section before this.
1. Press the MODE/ESC button to access the main menu. Press
the UP or DOWN buttons so that "Information" is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until "Time Information" is dis-
played, press ENTER.
3. Press UP or DOWN buttons, until "Clear Lamp Time" is dis-
played, and press ENTER.
4. Either "Off" or "On" will be displayed, use the UP and DOWN but-
tons to toggle between.
5. Press ENTER to confirm your selection or press MODE/ESC to
exit.
Temperature Info - This will allow you to check the moving head
temperature.
1. Press the MODE/ESC button to access the main menu. Press
the UP or DOWN buttons so that "Information" is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until "Temperature Info" is dis-
played, press ENTER.
3. "Head Temperature" will now be displayed, press ENTER.
4. "XXX" will now be displayed. "XXX" represents the current tem-
perature of the moving head.
5. Press ENTER or press MODE/ESC to exit.
ADJ Products, LLC - www.adj.com - Vizi Roller Beam 2R Instruction Manual Page 22
System Menu Vizi Roller Beam 2R
Software Version - This will allow you to see the software version
you are currently running.
1. Press the MODE/ESC button to access the main menu. Press
the UP or DOWN buttons so that "Information" is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until "Software Version" is dis-
played, press ENTER.
3. "VX.X" will now be displayed. "X.X" represents the software ver-
sion.
4. Press ENTER or press MODE/ESC to exit.
LAMP CONTROL -
Lamp On/Off - With this function you can switch the lamp on or off
via the control board.
1. Press the MODE/ESC button to access the main menu. Press the
UP or DOWN buttons so that "Lamp Control" is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until "Lamp Off/On" is displayed,
press ENTER.
3. Either "Off" or "On" will be displayed, use the UP and DOWN but-
tons to toggle between.
4. Press ENTER to confirm your selection or press MODE/ESC to
exit.
Automatic On - With this function you can have the lamp automati-
cally turn On when when switching on the power.
1. Press the MODE/ESC button to access the main menu. Press the
UP or DOWN buttons so that "Lamp Control" is highlighted, then
press ENTER.
2. Press the UP or DOWN buttons until "Automatic On" is displayed,
press ENTER.
3. Either "Off" or "On" will be displayed, use the UP and DOWN but-
tons to toggle between.
4. Press ENTER to confirm your selection or press MODE/ESC to
ADJ Products, LLC - www.adj.com - Vizi Roller Beam 2R Instruction Manual Page 23
System Menu