Pioneer AVIC-HD3 Operation Manual page 175

MAN-HD3-SOFTW-EN.book Page 173 Wednesday, January 10, 2007 9:33 AM
Symptom
The map continually reorients itself.
The daylight display is used even
when the vehicle lights are on.
The display is very dim.
No sounds are heard.
The volume level will not rise.
The volume of beeps and navigation
guidance cannot be adjusted.
Adjusting the volume of navigation
guidance and beeps is not possible.
A strange sound is heard when the
vehicle comes close to a certain
place. (E.g. Dog barking)
An alarm sounds when you approach
the registered location and the set
image pops up, regardless of
whether [Address Book Icon] is set
to [Off].
Cause
Signals from the vehicle's speed
pulse are not being picked up prop-
erly.
The navigation system may not be
mounted securely in your vehicle.
Your vehicle is operating in Simple
hybrid mode.
The navigation system is installed
with an extreme angle exceeding the
limitation of the installation angle.
Indication of the position of your vehi-
cle is misaligned after a U-turn or
reversing.
The travelling direction is always set
to Heading Up.
[Day] is selected to [Day/Night Dis-
play].
The orange/white lead is not con-
nected.
The vehicle's light is turned ON, and
[Automatic] is selected on [Day/
Night Display].
The vehicle cabin temperature is
extremely low.
Picture quality adjustment of the dis-
play is not correct.
Display tilt is not at the proper set-
ting.
The volume level is low.
The attenuator or mute is on.
The speaker lead is disconnected.
You cannot adjust these parameters
with the VOL (8/2) button.
You cannot adjust them with the
VOL (8/2) button.
The sound for the entry of [Address
Book] is set.
This is a normal operation and not a
malfunction.
Action (See)
Check that the cables are properly
connected. If necessary, consult the
dealer that installed the system.
Check that the navigation system is
securely mounted and, if necessary,
consult the dealer that installed the
system.
Connect the speed signal input (pink
lead wire) of the power cable cor-
rectly, and reset the 3D Hybrid Sen-
sor memory ([Learning Status]).
Confirm the installation angle. (The
navigation system must be installed
within the allowed installation angle.
For details, refer to "Installation Man-
ual" and [Installation Angle Setup]
on page 85.)
Check whether or not the reverse
gear signal input lead (purple) is con-
nected properly. (The navigation sys-
tem works properly without the lead
connected, but positioning accuracy
will be adversely affected.)
Touch on the screen and change
the map display.
Check the [Day/Night Display] set-
ting ( Page 47) and make sure
[Automatic] is selected.
Check the connection.
Read about the [Day/Night Dis-
play] setting ( Page 47) and, if
desired, select [Day].
A Liquid Crystal Display (LCD) is
used, and such displays tend to
darken when cold. Wait for the vehi-
cle to warm up.
Refer to "Operating the picture
adjustment" ( Page 142) to adjust
the picture quality.
Press and hold the EJECT button to
adjust the tilt.
Adjust the volume level.
Turn the attenuator or mute off.
Check the connection.
Turn the volume up or down with
[Volume] in the [Settings] menu.
Turn the volume up or down accord-
ing to [Volume] ( Page 81) in the
[Settings] menu.
Set the sound setting of that entry to
[No Sound]. ( Page 62)
To turn off the sound output and
image pop up, select [No Sound]
and [No Picture].
173