Maintenance And Troubleshooting - NordicTrack Sl850 Bike User Manual

MAINTENANCE AND TROUBLESHOOTING

Inspect and properly tighten all parts of the exercise
cycle regularly. To clean the exercise cycle, use a
soft, damp cloth. Keep liquids away from the console
and keep the console out of direct sunlight.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, the Right Side Shield (27) must first be
removed. Remove the indicated M4 x 25mm Screws
(65) from the Left Side Shield (26).
65
26
65
Next, remove the indicated M5 x 25mm Screw (93)
and M4 x 16mm Screws (57) from the Right Side
Shield (27). Using an adjustable wrench, turn the
Right Pedal (21) counterclockwise and remove it. Turn
the Right Crank Arm (23) so that it is pointing toward
the front of the exercise cycle, and then slide off the
Right Side Shield.
27
57
23
21
27
57
93
Locate the Reed Switch (46). Turn the Right Crank
Arm (23) until the Magnet (30) is aligned with the
Reed Switch. Loosen, but do not remove, the indicat-
ed M4 x 16mm Screw (57). Slide the Reed Switch
slightly closer to or away from the Magnet. Then,
retighten the Screw. Turn the Right Crank Arm for a
moment. Repeat until the console displays correct
feedback. When the Reed Switch is correctly adjust-
ed, reattach the Right Side Shield (27) and the Right
Pedal (21).
HOW TO ADJUST THE DRIVE BELT
If you can feel the pedals slip whilst you are pedaling,
even when the resistance is adjusted to the highest
level, the Drive Belt (47) may need to be adjusted. To
adjust the Drive Belt, you must first remove the right
side shield. See HOW TO ADJUST THE REED
SWITCH at the left and remove the right side shield.
Next, turn the
indicated M10
Nylon Locknut
(63) until the
Drive Belt (47) is
properly tight-
ened. Then, reat-
tach the right
side shield.
PULSE SENSOR TROUBLESHOOTING
If the chest pulse sensor does not function properly,
see CHEST PULSE SENSOR TROUBLESHOOTING
on pages 9 and 10. If the handgrip pulse sensor does
not function properly, see step 5 on page 14.
23
Front View
46
23
57
30
47
63