Adjusting The Speaker Output Levels - Pioneer AVH-P8400BT Owner's Manual

Section
13 Menu operations
1 Display the DSP function menu.
Refer to Introduction of menu operations on
page 46.
2 Touch Speaker Setting.
3 Touch a or b to select Subwoofer (sub-
woofer).
Front (front speakers)—Center (center speak-
er)—Rear (rear speakers)—Subwoofer (sub-
woofer)—Phase (subwoofer setting)
4 Touch d to turn subwoofer output on.
# To turn subwoofer output off, touch c.
5 Touch b and then touch c or d to se-
lect the phase of subwoofer output.
Reverse—Normal
Note
When playing a 2-channel mono source with
Dolby Pro Logic II turned on:
! No sound is emitted if the center speaker set-
ting is Small or Large and no center speaker
is installed.
! Sound is only emitted through the center
speaker if it is installed and set to Small or
Large.
Adjusting the speaker output
levels
Fine adjustments of the speaker output level
can be made by listening to audio output.
First, use the test tone to adjust the speaker to
an approximate level, and then use this func-
tion to make fine adjustments.
1 Display the DSP function menu.
Refer to Introduction of menu operations on
page 46.
2 Touch Speaker Level.
3 Touch a or b to select the speaker to
be adjusted.
Front-L (left front speaker)—Center (center
speaker)—Front-R (right front speaker)—
54
En
Rear-R (right rear speaker)—Rear-L (left rear
speaker)—Subwoofer (subwoofer)
# Speakers with the size set to Off cannot be se-
lected. (Refer to Setting the speaker setting on the
previous page.)
4 Touch c or d to adjust the speaker out-
put level.
Range: +10 to –10
Note
You will get the same results whether you adjust
the speaker output levels with this mode or with
Test Tone.
Selecting a cross-over frequency
The frequency under which sounds are repro-
duced through a subwoofer can be selected.
For example, if the size of one of the installed
speakers is set to Small, you can select the fre-
quency under which sounds will be repro-
duced through a speaker set to Large or a
subwoofer.
1 Display the DSP function menu.
Refer to Introduction of menu operations on
page 46.
2 Touch Cross Over.
3 Touch a or b to select the speaker to
be adjusted.
Front (front speakers)—Center (center speak-
er)—Rear (rear speakers)—Subwoofer (sub-
woofer)
4 Touch c or d to select the cross-over
frequency.
63Hz—80Hz—100Hz—125Hz—160Hz—
200Hz