Setting The Clock; Resetting The Microprocessor; Demo Mode - Pioneer AVH-P8400BT Owner's Manual

Basic operations
2 Push on the bottom of the front panel
until it clicks into place.

Setting the clock

1 Switch to Clock Adjustment display.
Refer to Basic operations on page 10.
2 Select the item to set.
3 Touch a or b to set the correct date
and time.

Resetting the microprocessor

By pressing RESET, you can reset the micro-
processor to its initial settings without chan-
ging the bookmark information.
The microprocessor must be reset in the fol-
lowing situations:
! Before using this unit for the first time after
installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1 Turn the ignition switch OFF.
2 Press RESET with a pen tip or other
pointed instrument.
RESET button
Note
Switch your engine ON or set the ignition switch
to ACC ON before pressing RESET in the follow-
ing situations:
! After completing connections
! When erasing all stored settings
! When resetting the unit to its initial (factory)
settings

Demo mode

The feature demo automatically starts when
you select Off for the source and continues
while the ignition switch is set to ACC or ON.
To cancel the feature demo, press and hold
MUTE. Press and hold MUTE again to restart.
Operating the feature demo while the car en-
gine is turned off it may drain the battery
power.
Important
Failure to connect the red lead (ACC) of this unit
to a terminal coupled with ignition switch on/off
operations may lead to battery drain.
Section
04
15
En