First Time Installation - Strong SRT 5438 User Manual

First Time Installation

Note: Be sure to turn on the main power switch at the rear of the unit before using it.
After all the connections have been made properly, switch on your TV. Make sure the unit
is connected to power and press Power on the remote control to switch on the unit. If you
are using the unit for the first time or restored to factory default, a First Time Installation
menu will be displayed to guide you through the initial setup to set the time zone, the
daylight saving, the TV screen type and scan channels. Please use the remote controller
to finish the setup.
When the scanning is finished, all active channels will be stored automatically. The last
stored channel will be viewed. (In case you want to stop the scanning, press the EXIT
key to exit. The already scanned channels will be stored).
Now you are ready to watch digital terrestrial TV channels and listen to radio broadcasts.
To skip the First Time Installation screen, you can press the MENU/EXIT key to bring up
the main menu (please refer to page 16 for operation guidance)
11