Section 3 - Installing The Gun; Mtx 3502 Gun Installation - Miller MTX 3502 Robot Gun Owner's Manual

SECTION 3 – INSTALLING THE GUN

3-1. MTX 3502 Gun Installation

6
MRK-5 And MRH
OM-1556 Page 6
2
1
3
1
4 5
3
2
6
MR-5
Y Turn Off welding power
source and Robot Control,
and disconnect input power
before inspecting or install-
ing.
1 Mounting Plate
2 Axis 5 (Phi Axis) Output Hub
3 Axis 5 (Phi Axis)
For MRK-5 and MRH robot models,
install gun to mounting plate on Axis
5 (Phi Axis) output hub using
supplied socket-head screws.
4 30 Mounting Bracket
5 Insulating Plate
For MR-5 robot model, install 30
mounting bracket to mounting plate
on Axis 5 (Phi Axis) output hub us-
ing supplied socket-head screws.
Install gun to insulating plate on 30
mounting bracket using supplied
socket-head screws.
6 Adapter
Connect outlet cable to adapter by
tightening outlet cable nut onto
adapter.
Tighten jam nut against outlet cable
nut.
Connect shock sensor leads from
gun to outlet cable leads and con-
nect leads at opposite end of outlet
cable to leads or matching connec-
tor at manipulator. Polarity is not im-
portant.
S-0519 / ST-800 238