Manual registration/Pairing
If auto registration fails or if you register a
handset of a different model, register your
handset manually to the base station.
1
Select [Menu] >
press [OK] to confirm.
2
Press and hold
5 seconds.
Note
•
For models with an answering machine, you hear a
confirmation beep.
3
Enter the system PIN/passcode. Press
[Clear] to make corrections.
4
Press [OK] to confirm the PIN/passcode.
» Registration is complete in less than 2
minutes. The base automatically assigns
a handset number to the handset.
Note
•
If the PIN/passcode is incorrect or no base is found
within a certain period, your handset displays a
notification message. Repeat the above procedure if
registration fails.
•
The preset PIN/passcode is 0000. No change can be
made on it.
Charge the handset
Place the handset on the charging cradle to
charge the handset. When the handset is
placed correctly on the base station, you hear
a docking tone (see 'Set the docking tone' on
page 23).
» The handset starts charging.
10
EN
> [Register], then
on the base station for
Note
•
Charge the batteries for 8 hours before first use.
•
If the handset becomes warm when the batteries are
being charged, it is normal.
•
Over time, capacity of batteries decreases. This is a
normal battery behavior.
Your phone is now ready to use.
Check the battery level
The battery icon displays the current battery
level.
When the handset is off the base
station/charger, the bars indicate
the battery level (from full to low).
When the handset is on the base
station/charger, the bars flash until
charging is complete.
The empty battery icon flashes.
The battery is low and needs
recharging.
If you are on the phone, you hear warning
tones when the batteries are almost empty.
The handset turns off when the batteries are
completely empty.