Table of Contents
Advertisement
4-1. Important Information Regarding CE Products (Sold Within The EU)
A. Information On Electromagnetic Fields (EMF)
!
This equipment shall not be used by the general public as the EMF limits for the general public might be exceeded during welding.
This equipment is built in accordance with EN 60974−1 and is intended to be used only in an occupational environment (where the general public
access is prohibited or regulated in such a way as to be similar to occupational use) by an expert or an instructed person.
Wire feeders and ancillary equipment (such as torches, liquid cooling systems and arc striking and stabilizing devices) as part of the welding
circuit may not be a major contributor to the EMF. See the Owner's Manuals for all components of the welding circuit for additional EMF exposure
information.
S
The EMF assessment on this equipment was conducted at 0.5 meter.
S
At a distance of 1 meter the EMF exposure values were less than 20% of the permissible values.
B. Information On Electromagnetic Compatibility (EMC)
!
This Class A equipment is not intended for use in residential locations where the electrical power is provided by the public low−
voltage supply system. There may be potential difficulties in ensuring electromagnetic compatibility in those locations, due to
conducted as well as radiated disturbances.
IEC/TS 61000−3−4 may be used to guide the parties concerned by the installation of arc welding equipment with an input current above 75 Amps
in a low-voltage network.
4-2. Serial Number And Rating Label Location
The serial number and rating information for the power source is located on the front or the rear of the machine. Use the rating labels to determine
input power requirements and/or rated output. For future reference, write serial number in space provided on back cover of this manual.
4-3. Specifications
Rated
Amperage/Voltage
Welding
Model
Output
100 − 1250 A In CC
1000 A @ 44
1000
Volts DC,
Amp
100% Duty
10 − 60 V In CV
Cycle
*While idling
Notes
OM-229 253 Page 14
SECTION 4 − INSTALLATION
Max
Range DC
OCV−DC
Rating
Mode
66 VDC**
Mode
**Open-circuit voltage is 26 volts DC if unit is equipped with optional low open-circuit voltage.
Amperes Input at
Rated Load Output,
IP
60 Hz, Three-Phase
230 V 460 V 575 V 380 V 400 V 440 V
180
90
72
5.8*
2.9*
2.4*
21M
ce-emf 1 2010-10
ce-emc 5 2010-10
Amperes Input at
Rated Load Output,
50 Hz, Three-Phase
KVA
111
105
96
73
5.2*
5.0*
4.5*
3.2*
KW
53
0.5*
Hide quick links:
Advertisement
Table of Contents
Troubleshooting
