Typical Mig Process Control Settings - Miller Electric M-10 Gun Owner's Manual

8-2. Typical MIG Process Control Settings

NOTE
These settings are guidelines only. Material and wire type, joint design, fitup,
position, shielding gas, etc. affect settings. Test welds to be sure they comply to
specifications.
Low voltage: wire stubs into work
High voltage: arc is unstable (spatter)
Set voltage midway between high/low voltage.
Voltage controls height and width of
weld bead.
Wire speed (amperage) controls weld penetration
(wire speed = burn-off rate)
Select voltage and wire feed
speed from parameter chart
located on inside of door.
OM-1328 Page 31
Ref. 803 809-B