Do you have a question about the MILLERMATIC 35 and is the answer not in the manual?
Questions and answers
fred johnson
April 21, 2025
welder runs, wire feed ok, but no arc
1 comments:
Mr. Anderson
May 11, 2025
A Miller Electric Millermatic 35 welder running wire feed but no arc could be caused by a few potential issues:
1. No power to the welding gun – A faulty trigger switch or connection in the gun can prevent voltage from reaching the contact tip. 2. Open circuit in the gun or cable – Broken or loose connections between the power source and the gun can stop current flow. 3. Faulty contactor or relay – If the internal contactor fails, it won’t deliver welding current to the gun. 4. Missing or poor ground connection – If the ground clamp is not connected properly, the arc will not start. 5. Internal power supply issue – A failure in the main transformer or rectifier can prevent arc voltage.
Each of these should be checked to diagnose and fix the problem.
This answer is automatically generated
Ken MacDonald
July 16, 2025
Machine willnot start
Related Manuals for Miller Electric MILLERMATIC 35
Need help?
Do you have a question about the MILLERMATIC 35 and is the answer not in the manual?
Questions and answers
welder runs, wire feed ok, but no arc
A Miller Electric Millermatic 35 welder running wire feed but no arc could be caused by a few potential issues:
1. No power to the welding gun – A faulty trigger switch or connection in the gun can prevent voltage from reaching the contact tip.
2. Open circuit in the gun or cable – Broken or loose connections between the power source and the gun can stop current flow.
3. Faulty contactor or relay – If the internal contactor fails, it won’t deliver welding current to the gun.
4. Missing or poor ground connection – If the ground clamp is not connected properly, the arc will not start.
5. Internal power supply issue – A failure in the main transformer or rectifier can prevent arc voltage.
Each of these should be checked to diagnose and fix the problem.
This answer is automatically generated
Machine willnot start