Table of Contents
Advertisement
n DIP switch
SW No.
1-1
Always ON
1-2
Auto Cutter *1
1-3
Always ON
1-4
Command emulation
1-5
USB mode *2
1-6
2 colors printing
1-7
Reserved
1-8
Print head model *3
*1 The factory settings for enabling/disabling the auto cutter are as follows.
Models without auto cutter: Invalid (Switch 1-2 = on)
Models with auto cutter: Valid (Switch 1-2 = off)
Note: Do not enable the auto cutter for models without the auto cutter (i.e., models with a
tear bar). A mechanical error will occur.
*2 USB interface model only
*3 Do not change the default setting (Switch 1-8 = off).
Function
– 39 –
ON
Should be set on
Invalid
Should be set on
Star
Printer class
Valid
18 pin wire
OFF
Valid
ESC/POS
Vendor class
Invalid
9 pin wire
Advertisement
Table of Contents
