Miscellaneous Operating Features And Conditions; 11.4.1 Sas Physical Interface; Figure 10. Physical Interface - Seagate ST1200MM0007 Product Manual

11.4 M
ISCELLANEOUS OPERATING FEATURES AND CONDITIONS
The table below lists various features and conditions. A "Y" in the support column indicates the feature or condition is
supported. An "N" in the support column indicates the feature or condition is not supported.
Table 8 Miscellaneous features
Supported Feature or condition
N Automatic contingent allegiance
N Asynchronous event notification
N Synchronized (locked) spindle operation
Y Segmented caching
N Zero latency read
Y Queue tagging (up to 128 queue tags supported)
Y Deferred error handling
Y Parameter rounding (controlled by Round bit in Mode Select page 0)
Y Reporting actual retry count in Extended Sense bytes 15, 16, and 17
N Adaptive caching
Y SMP = 1 in Mode Select command needed to save RPL and rotational offset bytes
Table 9 Miscellaneous status
Supported Status
Y Good
Y Check condition
Y Condition met/good
Y Busy
Y Intermediate/good
Y Intermediate/condition met/good
Y Reservation conflict
Y Task set full
N ACA active
N ACA active, faulted initiator

11.4.1 SAS physical interface

Figure 10 shows the location of the SAS device connector J1. Figures 11 and 12 provide the dimensions of the SAS
connector.
Details of the physical, electrical, and logical characteristics are provided within this section. The operational aspects of
Seagate's SAS drives are provided in the SAS Interface Manual
Figure 10. Physical interface
S E P
EAGATE NTERPRISE ERFORMANCE
10K HDD 7 P M
V RODUCT
, R . C
ANUAL EV
45