NordicTrack Audiostrider 900 Elliptical User Manual page 11

10. Attach the Left Link Arm (30) to the Left Pedal
Arm (32) with an M8 x 15mm Patch Screw
(106), an M8.5 x 16mm x 1.5mm Washer (103),
and an Axle Cover (66).
Attach the Left Link Arm (30) to the left Upper
Body Leg (24) with an M8 x 25mm Patch Screw
(136), two M8.5 x 16mm x 1.5mm Washers
(103), two Axle Covers (66), a Link Arm Spacer
(74), and an M8 x 15mm Patch Screw (106) as
shown.
Attach the Right Link Arm (31) in the same
way.
11. Plug the power cord into the power socket at the rear of the elliptical exerciser (see HOW TO PLUG IN THE
POWER CORD on page 13). IMPORTANT: If the elliptical exerciser has been exposed to cold tempera-
tures, allow it to warm to room temperature before plugging in the power cord. If you do not do this,
the console displays or other electronic components may become damaged.
Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be
left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the
elliptical exerciser.
10
24
74
66
103
136
30
106
11
31
106
103
66
66
103
32