Table of Contents
Advertisement
2.
In the Managers IP Address area, specify the IP addresses of the managers to which you want traps to be sent.
For each manager IP you specify, specify the Trap Port, and for Send Trap for Alarms with Severity, select
the severity filter to determine which types of alarms will be forwarded.
3.
In the Send Trap for Alarms of Group section, you determine which alarms will be sent as SNMP traps to
each manager. In each manager column, select the alarm types you want to include for that manager.
4.
In the Trap Options area, select Standard traps include serial number if you want trap messages to include
the IDU serial number.
Select Report local traps of far end IDU if you want remote IDU trap messages to be reported locally.
Select Use different ID for each alarm type if you want each type of alarm to receive a unique ID.
Select Send "clear" traps with zero severity if you want a trap with a "clear" severity (instead of the alarm's
original severity) to be sent to the IP addresses you specified.
5.
For CLLI (Common Language Location Identifier), enter up to 18 characters that will represent your system
ID when traps are sent.
6.
For Heartbeat Period, a heartbeat signal will be generated every x minutes (the number you enter) to tell your
system that the trap mechanism is working.
7.
Click Apply to save the settings.
GE MDS Intrepid-HC HP Installation Guide
Trap Forwarding Configuration Window
2-11
Advertisement
Table of Contents
