Table of Contents
Advertisement
Additional Setup Using the NMS
Some of the initial setup procedures require the use of The NMS.
Once initial setup is complete, use The NMS to run the system on a daily basis.
Connecting to the Ethernet Port
1.
Connect a crossed Ethernet cable from your PC to the Ethernet Port. If the connection is to a LAN (wall
connection) use the standard Ethernet cable.
2.
Make sure the IP address on your PC is on the same sub-net as you defined in the MDS Intrepid-HC HP indoor
unit (in most cases, the first three numbers of the IP address must be identical, depending on the sub-net mask).
NMS PC Requirements
Before you install the NMS software, verify that your PC has the following minimum requirements:
For Windows
Processor:
Pentium 4, 2.8 GHz (minimum)
Memory (RAM):
256 MB minimum
Operating System:
Windows 2000 or above
Serial Port:
RS-232 (Hyper-Terminal)
For UNIX
Processor:
Blade 100 Ultra 5 (minimum)
Memory (RAM):
256 MB minimum
Operating System:
Solaris 8 or 10
Installing the Network Management Software (NMS)
Note: More detailed information about the NMS installation is provided in Chapter 5 - Operation.
1.
Insert the NMS CD in the CD drive.
2.
In Windows Explorer, double-click the setup.exe file.
The installation program begins.
3.
Follow the instructions displayed.
GE MDS Intrepid-HC HP Installation Guide
2-5
Advertisement
Table of Contents
