Disassembly For Repair - Kenwood TK-2102G Service Manual

■ Removing the case assembly from the chassis
1. Remove the two knobs q, cushion w and three round
nuts e.
2. Remove the two screws r.
3. Expand the right and left sides of the bottom of the case
assembly, then Iift and remove the chassis from the case
assembly t.
4. Taking care not to cut the speaker lead y, open the
chassis and case assembly.

DISASSEMBLY FOR REPAIR

■ Removing the TX-RX unit from the chassis
1. Remove the eleven screws u.
2. Remove the VOL/CH FPC from the TX-RX unit connector
(CN400) i.
3. Remove the solder from the antenna terminal using a
soldering iron, then lift the unit off o.
4. Remove the waterproof packing !0 and cushion !1 from
the antenna connector.
Note: The cushion cannot be reused. Affi x a new cush-
ion when you remove the cushion.
5. Remove the two screws !2 and remove the antenna con-
nector.
Note: When reassembling the unit in the chassis, be
sure to solder the antenna terminal.
■ Removing the lever
1. Press down the lever on the lower case !3 , insert a small
fl at-head screwdriver into the space between the case
and lever, open the case carefully !4 and lift the lever off.
Note: Do not force to remove the lever from the case.
Lever knob
Case assembly
TK-2102G
Antenna
terminal
CN400
5