Dtmf Number Display; Nd Of; Id Signal - Kenwood TK-7100 Instruction Manual

DTMF N D
UMBER ISPLAY
Note: This feature can only be activated when DTMF Signalling is turned OFF.
When you receive a DTMF code containing at least 3 digits, it will appear on the
display. Each successive digit will continue to scroll across the display, as long
as each digit is received within 1 second of the previous digit. If no digit is
received for more than 1 second, then a new digit is received, the display will
clear and begin with the new digit.
Cancel the DTMF Number Display by pressing any key other than VOL /
(left side).
You can transmit DTMF codes by entering them into an optional microphone with
a DTMF keypad (KMC-32).
B / E T ID S
EGINNING

ND OF

RANSMISSION IGNAL
Your dealer can enable or disable the Beginning/ End of Transmission
identification signals. These signals are used to access and release some
repeaters and telephone systems.
A Beginning of Transmission ID Signal is sent when you press the PTT switch.
An End of Transmission ID Signal is sent when you release the PTT switch.
19