Oven Light - GE Spacemaker JVM139K Use And Care Manual

To replace
disconnect power
at main fuse or
circuit breaker
panel or pull
plug.
Remove screw on right side of light compartment
cover and lower cover until it stops.

Oven Light

To replace your oven light, first
disconnect power at main fuse or
circuit breaker panel or pull
plug. Remove the top grill by
taking out the 2 screws that hold it
in place.
replaced are cool
before removing.
Break the adhesive
seal by gently
unscrewing the bulbs.
REMOVE SCREW Replace
incandescent bulbs (WB02X4253) available from your
GE supplier. High intensity 40-watt bulbs (40S 11 N/l ),
which are available in supermarkets and hardware
stores, may also be used for replacements. Raise light
compartment cover and replace screw. Connect
electrical power to microwave oven.
Next, remove the single screw
located above door near center of
oven that secures light housing.
Replace burned-out bulb with a
30-watt incandescent bulb
GE
your supplier.
with 40-watt
Clean off the grease and dust on
hood surfaces often. Use a solution
of warm water and detergent.
About 1 tablespoon of ammonia
may be added to the water. Take
care not to touch the filters and
enamel surfaces with this solution;
ammonia will darken metal.
37