Cooktop Light; Oven Light - GE RVM120H Use And Care Manual

Clean off the grease and dust on
hood surfaces often. Use a warm
detergent solution. About 1
tablespoon of ammonia may be
added to the water. Take care not
to touch the filters and enameled
surfaces with this. Ammonia
will tend to darken metal.

Cooktop Light

REMOVE SCREW
To replace cooktop light, first
disconnect power at main fuse
or circuit breaker panel or pull
plug. Remove screw on right side
of light compartment cover and
lower cover until it stops.
Be sure bulbs to be replaced are
cool before removing. Break the
adhesive seal by gently unscrewing
the bulbs. Replace with 40-watt
incandescent bulbs (WB2X4253)
available from your Hotpoint
supplier. High intensity 40-watt
bulbs (40SllN/1) which are available
in supermarkets and hardware stores
may also be used for replacements.
Raise light compartment cover and
replace screw. Connect electrical
power to microwave oven.
19

Oven Light

To replace your oven light, first
disconnect power at main fuse
or circuit breaker or pull plug.
Remove the top grill by taking off
3 screws which hold it in place.
Next, remove the single screw
located above door near center of
oven that secures light housing.
Remove bulb and replace with
30-watt incandescent bulb
(WB2X4235) available from your
Hotpoint supplier. Secure light
housing with screw.