Smooth Fitness FX20HR User Manual page 25

How to use MOTION CONTROL
1. Press the button on the console to switch
the motion control function on and off:
•
When the LED light is ON the MOTION
CONTROL is active.
•
When the LED light is OFF the MOTION
CONTROL is off.
2. After switching on the MOTION CONTROL wave
your right hand approximately 6 inches above the
motion sensor on the right handle bar to increase
the speed. The sensor will sound one short
BEEP per scan and speed up by 0.1 MPH per
BEEP. Holding your right hand approximately 6
inches above the right sensor constantly results
in the sensor sounding one long BEEP per
second and speeding up by 0.1 MPH per BEEP.
3. Wave you left hand approximately 6 inches
above the motion sensor on the left handle bar to
decrease the speed. The sensor will sound one
short BEEP per scan and decrease speed by 0.1
MPH. Holding your left hand approximately 6
inches above the left sensor constantly results in
the sensor sounding one long BEEP per second
and decreasing speed by 0.1 MPH per BEEP.
4. Wave both hands approximately 6 inches above
both motion sensors at the same time. The
sensor will sound two short BEEPs then stop the
belt.
Always switch off the MOTION CONTROL function by
pressing the button before turning off the power
to the treadmill.
25
FX20HR MOTORIZED TREADMILL
MOTION CONTROL OPERATION
2. Use right sensor to speed up.
3. Use left sensor to slow down.
4. Use both sensors to stop belt.
Visit us at: www.evofitness.com