Kyosho LAZER ZX-S EVOLUTION Instruction Manual page 18

1
'– •s —p ‚ Ì ƒoƒbƒeƒŠ •[ ‚ð •[ "d •B
Fully charge the Ni-Cd battery.
4
'– •s —p ƒ oƒbƒeƒŠ •[ ‚Ì ƒR ƒl ƒN ƒ^•[ ‚ð ‚ ‚È ‚®•B
Connect the Ni-Cd battery.
7
Žó•M‹@ ‚Ì ƒX ƒC ƒbƒ` ‚ð "ü ‚ê ‚é •B
Switch on the receiver.
ON
10
'– •s •ê •Š‚ª ˆÀ'S ‚Å ‚ ‚é ‚± ‚Æ ‚ð Šm "F•B
Make sure the running area is safe.
1
Žè‚à ‚Æ ‚É ŽÔ ‚ð ‰ñ Ž û‚· ‚é •B
After finishing running, collect your car.
Do not leave on the racing car.
STOP
4
'– •s —p ƒ oƒbƒeƒŠ •[ ‚Ì ƒR ƒl ƒN ƒ^•[
‚ð ‚Í ‚¸ ‚· •B
Disconnect the Ni-Cd battery.
18
'– •s Žè•‡ / PROPER OPERATING PROCEDURES
2
'— •M‹@ ‚Ì "d 'r ‚ð ƒ` ƒFƒbƒN •B
Check the transmitter batteries.
CH-2 CH-1
BATT.
5
'— •M‹@ ‚Ì ƒA ƒ" ƒeƒi ‚ð ‚Ì ‚Î ‚· •B
Extend the transmitter antenna.
8
ƒX ƒeƒA ƒŠ ƒ" ƒO ‚ª ƒvƒ• ƒ| ‚Ì ƒX ƒeƒB ƒbƒN ‚Ì
"®‚« ‚Æ ‚ ‚Á ‚Ä ‚¢ ‚é ‚©Šm "F•B
Make sure the model steers according
to your transmitter inputs.
CH-2 CH-1
BATT.
'– •s ‚ª •I ‚í ‚Á ‚½‚ç / AFTER FINISHING RUNNING
2
Žó•M‹@ ‚Ì ƒX ƒC ƒbƒ` ‚ð •Ø‚é •B
Switch off the receiver.
OFF
5
ŽÔ ‚Ì ‰˜ ‚ ê ‚ð ‚« ‚ê ‚¢ ‚É ‚Æ ‚é •B
Remove dirt from the chassis.
3
ƒX ƒ• ƒbƒgƒ‹ ‚Ì ƒX ƒeƒbƒN ‚ª ƒj ƒ... •[ ƒgƒ‰ ƒ‹ ‚Å
‚ ‚é ‚± ‚Æ ‚ð Šm "F•B
Make sure the throttle control is in neutral.
CH-2 CH-1
BATT.
6
'— •M‹@ ‚Ì ƒX ƒC ƒbƒ` ‚ð "ü ‚ê ‚é •B
Switch on the transmitter.
CH-2 CH-1
BATT.
OFF ON
9
ƒX ƒ• ƒbƒgƒ‹ •i ƒA ƒ" ƒv•j ‚ª ƒvƒ• ƒ| ‚Ì ƒX ƒeƒB ƒbƒN
‚Ì "®‚« ‚Æ ‚ ‚Á ‚Ä ‚¢ ‚é ‚©Šm "F•B
Make sure the speed (electric speed controller)
changes according to your transmitter inputs.
CH-2 CH-1
BATT.
3 '— •M‹@ ‚Ì ƒX ƒC ƒbƒ` ‚ð •Ø‚é •B
Switch off the transmitter.
CH-2 CH-1
BATT.
OFF ON
'– •s ‚³ ‚¹ ‚È ‚¢ Žž‚Í •A•K‚¸ "d
Œ¹ ƒ X ƒC ƒbƒ` ‚ð •wOFF•x ‚É ‚µ •A
ˆÀ'S ‚Ì ‚½‚ß •K‚¸ ƒj ƒJƒhƒoƒb
ƒeƒŠ •[ ‚Ì ƒR ƒl ƒN ƒ^•[ ‚ð "² ‚« •A
Šm "F‚· ‚é
–{ 'Ì ‚æ‚è ŠO ‚µ ‚Ä ‚¨ ‚- •B•@
CHECK
•¦ "- "M•A"- ‰Î ‚ Ì Œ´ ˆ ö ‚É ‚È ‚è ‚Ü‚· •B
When NOT using the model, always
switch off the receiver and transmitter!
Furthermore, disconnect the Ni-Cd
battery and remove it from the model!
¥This may lead to overheat and fires!
ON
OFF