IBM xSeries 330 Hardware Maintenance Manual page 96

10. Start up the system. The system-error light will either remain on or turn off. If
92
Hardware Maintenance Manual: xSeries 330 Type 8675
6. Orient the fan so that the air flow arrow on the side of the fan is pointing
toward the rear of the server.
Note: Proper air flow is from the front to the rear of the server.
7. Push the replacement fan assembly into the server until it is fully seated to
the bottom of the bracket.
Note: The following illustration might differ slightly from your hardware.
8. Connect the fan cable to the system board.
Note: To avoid damage to the server, fan cables must always be routed on the
sides of the fans. Cables routed on the bottom of the fan can get cut by
the fan bracket. Cables on the top will cause problems when replacing
the cover and reinstalling the server in a rack.
9. Replace the cover on the server; then, reinstall the server in the rack and
connect all external cables and power cords. See "Installing the cover" on
page 93).
the system-error light remains on you will have to turn off the server to
perform further troubleshooting.
Air flow