Push Button Configuration (Pbc) - TRENDnet N600 User Manual

TRENDnet User's Guide
4. Select a wireless access point or router then click the Select button start the WPS
configuration.
5. The wireless utility will automatically attempt to authenticate to your wireless
network.
6. If the WPS configuration was successful, the following window will appear.
© Copyright 2012 TRENDnet. All Rights Reserved.
7. If the WPS configuration was failed, the follow window will show on. Try to repeat
the steps again if this screen appears.

Push Button Configuration (PBC)

There are 2 ways to run WPS Push Button Configuration. Follow the steps below when
using the WPS configuration with the Push Button Configuration (PBC) method through
the wireless utility. Please note that WPS will attempt to authenticate in 120 seconds.
Make sure you allow this time frame to prevent any failures.
1. Click on the Push Button Configuration (PBC) button, the PIN is shown on the
button of the windows.
2. Push the WPS button on your wireless access point or router.
TEW-664UB
9