Honda Goldwing F6B Owner's Manual page 167

12/12/06 16:29:45 32MJG600_167
Front Wheel Installation
1. Reassemble the removed parts in the reverse order of removal.
Position the wheel between the fork legs and insert the front axle shaft
from the left side, through the left fork leg and wheel hub.
Align the index line of the front axle shaft with the recessed surface of the
fork leg.
Fit the brake disc carefully between the brake pads to avoid damaging the
pads.
2. Install the bolts and tighten to the specified torque:
front axle bolt:
59 N·m (6.0 kgf·m , 44 lbf·ft)
right caliper fixing bolts:
31 N·m (3.2 kgf·m , 23 lbf·ft)
left caliper socket bolts:
31 N·m (3.2 kgf·m , 23 lbf·ft)
3. Measure the clearance between the brake disc and the caliper holder on
each side with a 0.7 mm (0.028 in) feeler gauge.
If the feeler gauge inserts easily, remove it and tighten the axle pinch
bolts to the specified torque:
22 N·m (2.2 kgf·m , 16 lbf·ft)
If the feeler gauge cannot be inserted easily, loosen the left axle pinch bolt
and pull the left fork outward or push inward to adjust the clearance. Then
tighten the axle pinch bolts to the specified torque.
Recessed surface
Front axle shaft
Index line
157