Honda Goldwing F6B Owner's Manual page 110

12/12/06 16:23:38 32MJG600_110
FEATURES
(Not required for operation)
Input Jack Setup
The auxiliary input jack connector is located under the left fairing pocket. To
use it:
1. Attach a cloth to the cover and remove the cover with care using a flat-tip
screwdriver.
2. Open the left fairing pocket cover and remove the clips and grommet A.
3. Lift out the fairing pocket.
Grommet A
Cover
Clips
4. Plug the auxiliary input patch cord into the wire harness connector.
5. Route the auxiliary input patch cord through the hole in the bottom of the
fairing pocket.
6. Install the grommet B to left fairing pocket.
Do not pull on the auxiliary cord as the wires could be damaged.
Grommet B
Some portable audio systems may pick up noise from the ignition.
Adjust the volume of the portable audio system so that it is about the same
level as the GL's radio volume. If the volume of the portable audio system is
set too high, the sound coming out from the speakers or headset may be
distorted.
100
Clips
Fairing pocket
Wire harness connector
Auxiliary input patch cord
Auxiliary input patch cord