Honda NC700S Owner's Manual page 109

12 NC700S (NM-1)-32MGS600.book 106 ページ ２０１２年４月１８日 水曜日 午後６時１７分
Tyre Puncture u Removing Wheels
3. Adjust the drive chain.
4. Install and tighten the rear axle nut.
Torque: 98 N·m (10.0 kgf·m, 72 lbf·ft).
5. Tighten the drive chain adjusting nuts
lightly, then hold the adjusting nuts and
tighten the lock nuts.
Torque: 21 N·m (2.1 kgf·m, 15 lbf·ft).
6. After installing the wheel, apply the brake
pedal several times, then recheck the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
106
P. 83 7. (NC700SD only)
2
NOTICE
When installing the brake caliper into position, carefully
fit the brake disc between the pads to avoid scratching
them.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Install the parking brake caliper and
tighten the mounting bolts.
Torque: 31 N·m (3.2 kgf·m, 23 lbf·ft).
u Take care to prevent the brake caliper
from scratching the wheel during
installation.