Adjusting The Seat Height - Invacare Pronto M94 Owner's Manual

Adjusting the Seat Height

NOTE: For this procedure, refer to FIGURE 7.5 on page 52.
NOTE: The seat can be adjusted to five height positions in ½‐inch increments.
1. Remove the seat. Refer to Removing/Installing the Seat Assembly on page 50.
2. Remove the mounting screw and locknut that secures the adjustable height tube to the
support tube.
3. Adjust tube to desired mounting position. Refer to the following table for available
mounting positions.
CHAIR IS EQUIPPED WITH
VAN SEAT WITH FOOTBOARD
REAR ADJUSTABLE HEIGHT TUBE
Mounted in hole A
Mounted in hole B
Mounted in hole C
Mounted in hole D
Mounted in hole E
*NOTE: This mounting hole combination would result in a forward seat dump. Forward seat
dump is where the rear of the seat is higher than the front of the seat. The seat should never be
adjusted to a position that results in a forward seat dump.
**NOTE: This mounting hole combination cannot be used because it would cause the front
riggings of the wheelchair to interfere with other components of the chair.
4. Reinstall mounting screw and locknut (FIGURE 7.5). Securely tighten.
5. Repeat STEPS 2‐4 for the three remaining adjustable height tubes.
When reinstalling the seat verify that the seat brackets are engaged with the seat
clevis pins by pulling up on the latch bar.
6. Reinstall the seat. Refer to Removing/Installing the Seat Assembly on page 50.
Part No 1122145
AVAILABLE MOUNTING HOLES FOR
FRONT ADJUSTABLE HEIGHT TUBE
A
N/A**
N/A* N/A*
N/A* N/A*
N/A* N/A*
N/A* N/A*
WARNING
51
SECTION 7—SEAT
B C D
  
 
 
N/A*

N/A* N/A*
Pronto® M94™
E




