Section 6-Arms; Installing/Removing Flip Back Armrests; Installing; Removing - Invacare Pronto M94 Owner's Manual

With surestep

Hide thumbs Also See for Pronto M94:

Table of Contents

SECTION 6—ARMS

After ANY adjustments, repair or service and before use, make sure that all

attaching hardware is tightened securely - otherwise injury or damage may result.

Before performing any maintenance, adjustment or service verify that On/Off

switch on the joystick is in the Off position.

Make sure the flip back armrest release and height adjustment levers are in the

locked position before using the wheelchair.

NOTE: Flip back armrest release lever must be in unlocked position when placing armrest into the

arm sockets.

NOTE: For this procedure, refer to FIGURE 6.1 on page 45.

1. Slide the flip back armrest into the arm sockets on the wheelchair frame.

2. Install the quick release pin through the rear arm socket and flip back armrest.

3. Lock flip back armrest by pressing flip back armrest release lever into the locked

position (FIGURE 6.1).

4. Lift up on flip back armrest to make sure the armrest is locked in place.

5. Repeat STEPS 1‐4 for opposite flip back armrest.

1. Unlock flip back armrest by pulling flip back armrest release lever into the unlocked

position (FIGURE 6.1).

2. Remove the quick release pin that secures the flip back armrest to the wheelchair

frame.

3. Pull Up on the flip back armrest and remove the armrest from the arm sockets.

4. Repeat STEPS 1‐3 for the opposite flip back armrest, if necessary.

Pronto® M94™

WARNING

Part No 1122145

Table of Contents

Troubleshooting

Pronto m94 with surestep