SECTION 4—SAFETY INSPECTION/TROUBLESHOOTING
Information Gauge Display Diagnostics
DISPLAY
Information
Gauge
Display
Service Indicator Light Diagnostics
NUMBER
ERROR CODE
OF
DESCRIPTION
FLASHES
1
User Fault
2
Battery Fault
3
Left Motor Fault
4
Right Motor Fault
5
Left Park Brake Fault
6
Right Park Brake Fault
7
Remote Fault
8
Controller Fault
9
Communications Fault
10
General Fault
11
Incompatible or incorrect
Pronto® M94™
DESCRIPTION
All LEDs are off.
All LEDs are on.
Left RED LED is flashing.
Left to Right "chase" alter-
nating with steady display.
All LEDs are flashing slowly. Joystick has detected Out-
Release joystick to neutral and try again.
Charge the batteries. Refer to Charging Batteries on page 74.
Check that battery cables are connected properly. Refer to
Connecting/Disconnecting the Battery Wiring Harness on page 72.
If necessary, replace batteries. Refer to Installing/Removing the
Batteries on page 70.
Contact Invacare/Dealer for service.
Contact Invacare/Dealer for service.
Contact Invacare/Dealer for service.
Contact Invacare/Dealer for service.
Check to make sure joystick is connected properly.
Contact Invacare/Dealer for service.
Contact Invacare/Dealer for service.
Contact Invacare/Dealer for service.
Contact Invacare/Dealer for service.
Wrong type of remote connected. Contact Invacare/Dealer for
Remote
service.
DEFINITION
Power is off.
Power is on.
Battery charge is low.
Joystick is in program-
ming, inhibit and/or charg-
ing mode.
of-Neutral-at-Power-Up
mode.
POSSIBLE SOLUTION
26
COMMENTS
Fewer than three LEDs on
implies reduced battery
charge.
The batteries should be
charged as soon as possi-
ble.
The steady LEDs indicate
the current state of the
battery charge.
Release the joystick back
to Neutral.
Part No 1122145