Table of Contents
Advertisement
S
P
ON/ OFF
WITCHING
OWER
Press the
switch to switch the transceiver ON.
Press and hold the
transceiver OFF.
A
V
DJUSTING THE
OLUME
Press the ▲ key to increase the volume and the ▼ key to decrease the volume.
S
C
ELECTING A
HANNEL
Select your desired channel by pressing a key from 1 to 4.
If Group has been programmed onto a key, press the Group key to select the
second group of channels. While active, the LED beside the key lights. At this
time, press a key from 1 to 4 to select a channel from 5 to 8. To return to
channels 1 through 4, press the Group key again.
Note: You cannot use the Group function while operating in Emergency mode.
T
RANSMITTING
Note: Before transmitting, first monitor the channel to make sure it is not already in use.
1 Select your desired channel by pressing a channel key (1 ~ 4).
• If the channel is busy, wait until it becomes free.
2 Press the microphone PTT switch and speak into the microphone. Release
the PTT switch when you have finished speaking.
• For best sound quality at the receiving station, hold the microphone approximately
1.5 inches (3 ~ 4 cm) from your mouth.
R
ECEIVING
1 Select your desired channel by pressing a channel key (1 ~ 4).
2 When you hear a signal, readjust the volume level if necessary.
3 Respond to the call as described in step 2 of "T
6
BASIC OPERATIONS
switch for approximately 1 second to switch the
", above.
RANSMITTING
Hide quick links:
Advertisement
Table of Contents
