HP Surestore Tape Library Model 20/700 Installation Instructions Manual page 8

Figure 3. Terminating Power Jumper DLT Drive
Terminating Power Jumper—DLT Drive (H_65116)
1. DLT drive
2. Load latch
3. TERMPWR jumper (enabled)
6. Look inside the drive column area and determine the slot you wish to use for each drive.
7. Carefully guide the drive into its slot. Push it in as far as it will go and firmly seat the
8. Refer to Figure 4 and turn the thumbscrew clockwise until it is secure.
Following the lifting procedures described in Chapter 2 "Safety and ESD", of the Instal-
lation Manual firmly grasp the drive at the rear with one hand and place the other hand
under the drive mounting plate.
drive.
NOTE:In the following step, do not over tighten the thumbscrew.
62114 8