HP Surestore Tape Library Model 20/700 Installation Instructions Manual page 13

3. Route the cable for the first drive through the cutout
in the library floor.
NOTE: Use the figure to the right for an
example. Although the figure shows
Column 1 locations, the locations for
Column 0 are very similar.
CAUTION: Connector damage. Be careful not to
bend or damage the pins or connectors when
connecting the cable to the drive or SCSI bulkhead.
4. Connect the cable to a 68-pin jack on the library
bulkhead.
NOTE: If you are attaching to a 50-pin SCSI bus,
an adapter is required.
5. Connect a 6 in. daisy-chain cable from the second
68-pin connector to the Y-cable connector for the
next drive, if applicable. See the figure to the right
for an example.
6. Install the terminator either at the bulkhead jack or
to the device at the end of the SCSI bus.
7. Repeat steps 2 through 6 for all remaining drives, as
applicable.
8. Close and lock the small access door, if drives were
installed in Column 1.
NOTE:Ensure that all previous tasks have been completed before attaching the
SCSI terminators.
62114 13