Installing DLT Cable Connectors
The following procedures describe how to install the tape channel connectors for the tape
drives.
Standard Drive Column 0 Connectors.
NOTE: Drive column 0 is the standard drive column included in all libraries. It is
1.
2. Remove the SCSI "Y" channel cable and mounting screws from the drive box.
3. Refer to Figure 5 and insert the two channel connectors into the slots on the interior library
Figure 5. Tape Drive Cable Connectors
Tape Drive Cable Connectors (H_65226)
1. Interior bulkhead view
2. Exterior bulkhead view
4. From the rear bulkhead, thread the four mounting screws into the connectors.
5. Tighten the mounting screws with a 3/16-inch nutdriver.
6. Insert the single connector end into the DLT drive.
7. Repeat these steps for all drives in column 0.
8. When you are finished installing all drives, place the drive power switch(es) to the ON (|)
9. Close the rear door.
the column that contains the calibration label at the bottom. Also, some
of the following steps may require two people.
Go to the rear of the library, open the door, and locate the connector bulkhead.
bulkhead, next to the desired drive location.
position.
62114
10