HP Surestore Tape Library Model 20/700 Installation Instructions Manual page 16

17. Press the top and bottom slide-rail buttons, and use the handle to gently push the drawer
18. Replace the 13 screws (8 on the front and 5 along the left side) securing the EM drawer to
19. Obtain the MPW card. The MPW card is inserted into the CPCI card cage as described in
20. Hold the card so that the card connector aligns with the MPV card connector (circuit side
21. Slide the MPW card onto the guide rail and gently push it until it mates with the MPV card
22. Make sure the card latch engages (see Figure 21 for Steps 22 and 23).
23. Using a Phillips screwdriver, tighten the captive screw.
16
into the frame (see Figure 24).
Figure 24. Slide-Rail Button
the frame assembly. Refer to Figure 16.
CAUTION:
Possible esd damage: FOLLOW ESD PRECAUTIONS.
the next step.
out, components facing the MPC card).
connector (see Figure 25).
Figure 25. MPW Card Install
NOTE:
ONLY THE LOWER SLOT IS
SUPPORTED AT THIS TIME.
BE SURE TO INSERT THE MPW
CARD INTO THAT SLOT.