HP Surestore Tape Library Model 20/700 Installation Instructions Manual page 11

FOR 20/700 WITH 2ND DRIVE TOWER
C. MPM Replacement
1.
2. Turn the card slightly to the left and insert the mounting plate into the two threaded-studs.
3. Using a Torx T-10 driver, install the center MPM card screw. Refer to Figure 5.
4. Using a 3/8-in. hex driver, attach the upper and lower MPM card nuts. Refer to Figure 5.
5. Connect the P/J242 and P/J243 connectors to the MPM card. Refer to Figure 4.
6. Remove the ESD bag or cardboard from the grating.
7. Attach the new EM cover with four Torx T-15 screws (removed in Section A or B) on the
8. Return the system to operation following the procedures in the 20/700 Service Manual.
10/180 LVD SCSI COMPONENT INSTALLATION
D. MPV Card Installation
1.
2. Remove power from the library and drives by pushing the main circuit breaker down (off).
3. Open the lower cable clamp and unplug the SCSI Y cable from the Electronics Module
4. Remove the 13 screws (eight on front and five along left side) securing the EM drawer to
Locate the MPM card removed in Section A.
CAUTION: Possible ESD damage. Following ESD precautions, remove the MPM
card assembly from the anti-static bag.
front and the two on the side.
Open the library rear door.
(EM). Refer to Figure 15.
Figure 15. SCSI Y Cable
the frame assembly (see Figure 16).
11