HP Surestore Tape Library Model 20/700 Installation Instructions Manual page 8

CAUTION: Possible ESD damage. FOLLOW ESD PRECAUTIONS.
13. Obtain the MPW card. The MPW card is inserted into the CPCI card cage as described in
14. Hold the card so that the card connector aligns with the MPV card connector (circuit side
15. Slide the MPW card onto the guide rail and gently push it until it mates with the MPV card
16. Make sure the card latch engages (see Figure 8 for Steps 16 and 17).
17. Using a Phillips screwdriver, tighten the captive screw.
Note: If you removed an MPM card, skip to Step 20 otherwise, complete Steps 18
18. Remove the ESD bag or cardboard from the grating.
19. Install the new EM cover, using six No. 6-32 x 3/8 screws on the front and two on the side.
8
the next step.
out, components facing the MPC card).
connector (see Figure 11).
Figure 11. MPW Card Install
and 19 before proceeding.
NOTE:
ONLY THE LOWER SLOT IS
SUPPORTED AT THIS TIME.
BE SURE TO INSERT THE MPW
CARD INTO THAT SLOT.