Installing A Disk Drive - HP 3PAR StoreServ 7200 2-node Service Manual

Installing a Disk Drive

CAUTION:
are not filled with disk drives.
CAUTION:
Each disk drive includes a green and amber LED on the front to indicate disk drive status.
NOTE: All drives in a vertical column of an LFF drive enclosure must be the same speed and
type.
NOTE: Before beginning this procedure, review how to load the drives based on drive type,
speed, and capacity. For more information, see Guidelines for Installing Disk Drives in Disk
Enclosures in the HP 3PAR StoreServ 7000 Storage Installation Guide.
Installing a 2.5 inch disk drive (SFF)
1. Press the handle latch to open the handle.
2. Insert the disk drive into the enclosure with the handle opened from the top in the vertical
position.
3. Slide the disk drive into the enclosure until it engages; push firmly until it clicks.
Figure 13 7200 and 7400 Two Node System (HP M6710 Drive Enclosure)
Installing a 3.5 inch disk drive (LFF)
1. Press the handle latch to open the handle.
2. Position the disk drive so the handle opens from the left and slide it into the enclosure.
3. Push firmly until the handle fully engages and clicks.
Blank disk drive carriers are provided and must be used if all slots in the enclosure
To avoid potential damage to equipment and loss of data, handle disk drives carefully.
Repairing a Disk Drive 15