Interconnect Port Leds; Verifying Service Processor Leds - HP 3PAR StoreServ 7200 2-node Service Manual

Table 14 SAS port LEDs
Appearance
Green

Interconnect Port LEDs

The controller node has two interconnect ports and each includes two LEDs.
NOTE: Incorrectly configured interconnect cables illuminate amber port LEDs.
Figure 40 7200 Interconnect Ports LEDs
Figure 41 7400 Interconnect Ports LEDs
Table 15 Interconnect port LEDs
7200
7400

Verifying Service Processor LEDs

The HP 3PAR SP (Proliant DL320e) LEDs are located at the front and rear of the SP.
36 Understanding LED Indicator Status
Off
Flashing
A 7200 does not use any external interconnect links. Interconnect port LEDs should always be off.
Fault Amber
Status Green
Indicates
No activity on port. This LED does not indicate a Ready state with a solid
On as the I/O Module External Port Activity LEDs do.
Activity on port
On Failed to establish link connection
Off No error currently on link
Flashing 1. Interconnect cabling error
2. Controller node in wrong slot
3. Serial number mismatch between controller nodes
On Link established
Off Link not yet established