Changing The Jukebox Controller Id - HP SureStore 220mx User Manual

assigned one ID and one ID is assigned to each disk drive.
The default SCSI IDs are as follows
• jukebox controller = 3
If you are already using one of these IDs for your host bus adapter or
another SCSI peripheral device, follow the directions in one of the next
two sections to change either the jukebox controller or a drive ID.

Changing the Jukebox Controller ID

Start with READY or SECURE in the display.
1. Press
2. Press
3. Press
4. Press
5. Press
6. Press
CONFLICT displays if you attempt to set the jukebox controller and a
NOTE
drive to the same ID. Repeat the procedure and reset one of the IDs to
another, non-conflicting ID.
After you change an ID you may have to restart your host computer for
NOTE
the new ID to be recognized.
Chapter 3
disk drive 1 (lower drive) = 4
disk drive 2 (upper drive in a two-drive model) = 5
until SCSI ID * displays.
NEXT
. AC ID * displays. (" AC " is the "jukebox controller.")
ENTER
. AC ID 3 displays.
ENTER
or until the ID you want displays.
NEXT PREV
. SET # ( # is a number from 0-7) displays briefly and then
ENTER
A C ID * displays again. The ID you chose is now set.
two times to return to the READY state.
CANCEL
Operating the Jukebox
Changing SCSI IDs
3-23