HP SureStore 220mx User Manual page 50

NOTE
NOTE
NOTE
Operating the Jukebox
Using the Front Panel Features
Don't forget your security code. If you forget it, only your service
representative can reset the security code to the factory setting so you
can set a new code.
Start with READY or SECURE in the display.
1. Press until CONF * displays
NEXT
2. Press . CONF 0 and a flashing 0 displays.
ENTER
3. Press until CONF 17 displays.
NEXT
Starting from when you press
to enter the current security code.
4. Press . CODE 1 and a flashing 0 displays.
ENTER
5. Press until the first number of your current security code
NEXT
displays.
6. Press . CODE 2 and a flashing 0 displays.
ENTER
7. Press until the second number of your current security code
NEXT
displays.
8. Press . CODE 3 and a flashing 0 displays.
ENTER
9. Press until the third number of your current security code
NEXT
displays.
10. Press .
ENTER
If you entered an incorrect code, NO CONFIG displays briefly and then
CONF 17 displays. Repeat steps 4-10 again and enter the correct current
code.
After entering the current security code in the previous steps, you are
prompted to enter a new three-digit security code.
11. Press . NEW 1 and a flashing digit displays (the previous code
ENTER
1).
12. Press until the first number you want in your security code
NEXT
displays
13. Press . NEW 2 and a flashing digit displays (the previous code
ENTER
3-12
in the next step, you are prompted
ENTER
Chapter 3