Hoover IRONSPEED SRD 4107 User Manual page 14

Chapter 4.2 - Rinsing the Boiler for Scale Maintenance
12 -
GB
Ironspeeed_SR__1-15_union_pprod3.indd 12
In order to extend the life of your appliance, you should rinse the boiler to avoid
scale deposit in the boiler. You should rinse it every 2 months or wait until
the "rinse" light (1e) ashes.
Models with "Rinse" Light
Only remember to clean the boiler before use next time you plan to iron. Proceed as
followed:
Before going on, be sure that the appliance is cooled down and unplugged for at
least 2 hours.
the calc removal cap (17). Unscrew the boiler rinse safety cap anti-clockwise with
a coin and remove it. Fill the boiler with 0,2 litres of tap water using a bottle and a
in the sink. We recommend repeating this operation twice. Screw the boiler rinse
safety cap with a coin and put back the calc removal cap (17).
Next time you will plug and switch on your appliance, the rinse light (1e) will
start your ironing session immediately.
Models Without "Rinse" Light
Before proceeding, be sure that the appliance is cooled down and unplugged for at
least 2 hours.
the calc removal cap (17). Unscrew the boiler rinse safety cap anti-clockwise with
a coin and remove it. Fill the boiler with 0,2 litres of tap water using a bottle and a
in the sink. We recommend repeating this operation twice. Screw the boiler rinse
safety cap with a coin and put back the calc removal cap (17).
In any case, do not use any descaling products to clean or rinse the boiler.
Fig. 11: Cleaning Operation
13
11-12-2009 9:59:58