INSTRUMENT AND CONTROL FUNCTIONS
Seat
To remove the seat
Remove the bolts, and then pull the
seat off.
4
1. Bolt
To install the seat
1. Fit the slot in the seat onto the pro-
jection on the fuel tank, and insert
the projection on the seat into the
seat holder as shown.
EAU46280
1
2
3
1. Slot
2. Projection
3. Seat holder
2. Place the seat in the original posi-
tion, and then tighten the bolts.
TIP
Make sure that the seat is properly se-
cured before riding.
2
Adjusting the front fork
Always adjust both fork legs equal-
ly, otherwise poor handling and loss
of stability may result.
This front fork is equipped with rebound
damping force adjusting screws and
compression damping force adjusting
screws.
NOTICE
To avoid damaging the mechanism,
do not attempt to turn beyond the
maximum or minimum settings.
Rebound damping force
1. Rebound damping force adjusting screw
4-7
WARNING
EAU41471
EWA10180
ECA10101