Cleaning And Lubricating The Drive Chain - Yamaha YZ85(Z) Owner's Manual

PERIODIC MAINTENANCE AND ADJUSTMENT
to chain slippage or breakage.
To prevent this from occurring,
keep the drive chain slack with-
in the specified limits.
TIP
Using the alignment marks on each
drive chain puller, make sure that both
drive chain pullers are in the same po-
sition for proper wheel alignment.
2
7
5
1. Axle nut
2. Drive chain puller
3. Locknut
4. Drive chain slack adjusting bolt
5. Alignment marks
3. Tighten both locknuts and the axle
nut to the specified torques.
Tightening torques:
Locknut:
16 Nm (1.6 m·kgf, 11 ft·lbf)
Axle nut:
[ECA10571]
90 Nm (9.0 m·kgf, 65 ft·lbf)
3
4
Cleaning and lubricating the
drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrica-
tion chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
The drive chain must be lubricated
after washing the motorcycle and
riding in the rain or wet areas.
1. Remove all dirt and mud from the
TIP
For a thorough cleaning, have a
Yamaha dealer remove the drive chain
and soak it in solvent.
2. Spray Yamaha Chain and Cable
7-22
drive chain with a brush or cloth.
Lube or a high-quality spray-type
drive chain lubricant on the entire
chain, making sure that all side
plates and rollers have been suffi-
ciently oiled.
EAU23015
ECA10582