Verifying The Configuration; Backing Up The Configuration; Recovering The Admin Password - Cisco MDS 8/12c User Manual

Cisco mds 8gb fabric switch for hp bladesystem c-class user guide (5697-0339, november 2010)
Table of Contents

Advertisement

switch(config-if)# no shutdown

Verifying the configuration

To verify a switch configuration, enter the following commands:
switch# show interface ext1
switch# show module

Backing up the configuration

To backup a switch configuration, enter the following command:
switch# copy running-config startup-config

Recovering the admin password

You may need to recover the admin password on the switch if the user does not have another user
account on the switch with network-admin privileges.
CAUTION:
Recovering the admin password requires a power-cycle of the switch. Configuration changes made since
the last saved configuration are lost.
To recover the admin password on the switch:
1.
Log in to the OA/iLO port through the console or telnet.
2.
Connect to the appropriate Cisco MDS 8Gb Fabric Switch bay:
OA> connect interconnect x
Where x is the bay number where the switch is installed.
3.
Reset the switch.
4.
During the bootup of the switch, issue the following command one or more times at the OA console or
telnet session until you see the loader prompt:
<ctrl> c
5.
Verify that you now see the loader prompt, loader>.
6.
View the kickstart image in bootflash:
loader> dir bootflash:
For example: m9100-s3ek9-kickstart-mz.5.0.1b.bin
7.
Boot the kickstart image:
loader> boot kickstart_image
For example: boot m9100-s3ek9-kickstart-mz.5.0.1b.bin
8.
Verify that you see the boot prompt, switch(boot)#.
9.
Enter the configuration mode:
switch(boot)# config t
10.
Enter a new admin password:
switch(boot)(config)# admin-password <new password>
switch(boot)(config)# exit
switch(boot)#
1 1.
View the system image in bootflash:
switch(boot)# dir bootflash:
For example: m9100-s3ek9-mz.5.0.1b.bin
12.
Load the system image:
switch(boot)# load bootflash: system_image
For example: load bootflash:m9100-s3ek9-mz.5.0.1b.bin
13.
Verify that you see the switch login prompt, switch login#.
14.
If necessary, reset the SNMP admin password after logging in to the switch, as in the following
example:
18
3 Login and Configuration

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mds 9000

Table of Contents