HP 6125XLG Configuration Manual page 77

Security model
Authentication without
privacy
No authentication, no
privacy
To configure SNMPv3 basic parameters:
Step
1. Enter system view.
2. (Optional.) Enable the SNMP
agent.
3. (Optional.) Configure the
system contact.
4. (Optional.) Configure the
system location.
5. Enable SNMPv3.
Security model
keyword for the group
authentication
Neither authentication
nor privacy
Command
system-view
snmp-agent
snmp-agent sys-info contact
sys-contact
snmp-agent sys-info location
sys-location
•
In non-FIPS mode:
snmp-agent sys-info version
{ all | { v1 | v2c | v3 }* }
•
In FIPS mode:
snmp-agent sys-info version v3
71
Security key settings
for the user
Authentication key
None
Remarks
N/A
By default, the SNMP agent is
disabled.
The SNMP agent is enabled
when you perform any command
that begins with snmp-agent
except for the snmp-agent
calculate-password command.
By default, no system contact is
configured.
By default, no system location is
configured.
•
If the device starts up with the
initial settings (or empty
configuration), SNMPv3 is
enabled by default.
•
If the device starts up with the
default configuration file (or
factory defaults):
For more information about the
startup configuration, see
Fundamentals Configuration
Guide.
Remarks
If no authentication key is
configured, SNMP
communication will fail.
The privacy key (if any) for
the user does not take
effect.
The authentication and
privacy keys, if
configured, do not take
effect.
In non-FIPS mode,
SNMPv1, SNMPv2c, and
SNMPv3 are enabled by
default.
In FIPS mode, SNMPv3 is
enabled by default.